The CE-25A, a 10-tonne electric commercial aircraft developed by COMAC with battery maker CATL and others, made its first crewed flight in Binzhou, Shandong, on the 14th. China's aviation regulator has accepted its type-certificate application.
China's domestically developed 10-tonne electric commercial aircraft CE-25A flew with people on board for the first time on the 14th in Binzhou, Shandong province. Huanqiu and The Paper, citing state broadcaster CCTV, reported that two pilots and one flight-test engineer were aboard. According to the CCTV release carried by Sina, the test lasted 57 minutes 46 seconds, including 16 minutes 38 seconds airborne over 60.4 kilometres. Officials said the aircraft performed normally and all indicators met expectations.
광고 문의 · 300×250The flight was billed as a crewed intelligent flight: pilots monitored from the cockpit and could intervene, while autonomous systems flew the mission. A report by IT Home carried on NetEase said this brings testing closer to the pilot-plus-intelligent-system model envisaged for commercial service than purely unmanned flights. The CE-25A had already made an unmanned autonomous maiden flight on February 2 this year and has since completed 19 unmanned autonomous verification flights.
19 seats, 300 km/h, ten ducted fans on the wings
According to The Paper, the CE-25A has a maximum take-off weight of 10 tonnes and seats 19 passengers, intended for intercity commercial flights. It cruises at 300 km per hour at 2,400 metres with a range of 400 km, though IT Home put the design range at 400 to 500 km. In the name, C stands for China and COMAC, E for electric, 25 for compliance with CCAR-25, China's airworthiness rules for transport-category aircraft, and A for the first product.
Its propulsion also differs from conventional turboprops. IT Home reported that five electric ducted fans sit atop each wing, ten in total, integrated into the wing as a distributed electric ducted propulsion system designed to keep the aircraft controllable even if some units fail. The aircraft reportedly uses condensed-state batteries with an energy density of 500 Wh/kg.
Battery maker and planemaker join forces
The aircraft was developed by COMAC, CATL and Shanghai Jiao Tong University among others. According to reports, the three set up a joint venture in July 2023 to develop aviation electric propulsion, with CATL and COMAC each holding 47 percent. The aircraft completed ground taxi tests in late October, moving from scale models and drawings to full-scale verification.
Commercial service is still some way off. The Civil Aviation Administration of China has accepted the type-certificate application, formally starting the airworthiness review, but IT Home noted that certification and passenger operations will require extensive compliance testing and review. Aviation batteries must meet both thermal-runaway protection and cycle-life requirements, a validation logic quite different from automotive batteries. With electric aircraft worldwide still largely at the small-aircraft testing stage, the certification of a 10-tonne model is likely to draw industry attention.